In 2016 we brought you the AT, Andy Timmons artist signature pedal
and we're really proud to bring you the next iteration of this
phenomenal stomp box, The AT+.
The JHS Pedals AT is Andy Timmons
signature overdrive pedal that gives Andy his unmistakable lead and
rhythm tone. Upon purchasing a JHS Angry Charlie in 2013, Andy began
using it as his primary tone and soon after got in touch with Josh Scott
about modifying it for his needs. Through going back and forth and
tailoring it to Andy’s tastes, the “@“ was born and eventually released
into production in 2016. This pedal gives you all the soaring overdrive
and distortion that you hear from Andy with plenty of options to craft
your tone with your rig. So pay ATtention and we’ll see what makes the
AT rock.
Does the AT+ sound the same as the original AT?
Yes!
The drive channel of the AT+ is identical to our original AT pedal.
No changes were made whatsoever and the controls remain the same.
They include Volume, EQ, Drive, Air, and a three-way toggle for 25-watt,
50-watt, or 100-watt modes. The Volume gives you plenty of headroom to
play with, while the Drive control has a wide range from high gain blues
to thunderous distortion. The tone controls work together to give you
the ability to shape your tone and sit perfectly in a mix. The EQ works
as a standard bright/dark tone control, while the Air control rolls in
top end like a presence control so you can have just the right amount of
brightness for articulation and clarity. The three-way toggle gives you
the feel of different wattage amplifiers. The up position is the
25-watt setting with the most compression and saturation with the least
amount of volume. The down position is the 50-watt setting for a good
balance of compression and openness. The middle position is the 100-watt
position for tons of volume and open crunch while being less focused.
Two channels are better than one!
New
to the AT+ is an independent foot-switchable Boost...essentially
creating a second channel and gain stage for the pedal. The boost side
of the AT+ is a slightly dirty and overdriven pre-boost that allows you
to hit the front end of the AT drive channel and achieve more saturation
and definition for applications where you need more. Since the Boost
is independent, it can be used alone to drive your amp or other drive
pedals in conjunction with the AT+ drive channel.
This pedal
requires standard 9V DC Negative power, consumes 15 mA, and measures
2.2"x4.8"x1.6". You can safely run “The AT“ at 18 or 9 volts