The Slötvå Multi Texture Reverb is a variant of the Slö but adds on the
ability to create and save three presets. Save your favorite dreamscapes
by simultaneously pressing and holding down on the bypass and sustain
switches. Scroll through them by simultaneously pressing and releasing
bypass and sustain.
The
Slötvå Multi Texture Reverb is a variant of the Slö but adds on the
ability to create and save three presets. Save your favorite dreamscapes
by simultaneously pressing and holding down on the bypass and sustain
switches. Scroll through them by simultaneously pressing and releasing
bypass and sustain.
The
Slötvå allows players to create lush, modulated, sleepy, and ambient
soundscapes. Stocked with three different algorithms specifically
designed to invoke textures for bringing dreams from your subconscious
to reality.
The
toggle switch allows three different reverb modes, Dark (Lower Octave),
Rise (Ambient Swell), and Dream (Latching Pad), while secondary
functions on the switch change between different wave shapes for the
modulation on the reverb trail.
Combine deep modulation with long washy trails and experience, the Slötvå.
ALGORITHMS:
DARK –
Add a lower octave to your reverb trail. Here you'll create deep and
wide atmospheric sounds and channel nightmarish soundscapes. X knob sets
the level of a -1 octave signal that feeds the reverb.
RISE –
This is an auto-swell reverb for beautiful cinematic swells. Don't rush
it. Let it breathe and gently wake up. X knob sets the amount of time
it takes the reverb to swell in after a note is played. Set lower for
shorter rise times and higher for longer rise times.
DREAM –
Lush reverb with a latching pad function. Press the sustain switch to
latch signal. Experiment with the X knob to add vibrato over the pad.
Press sustain again and the pad will decrescendo according to where the
decay knob is set. X knob sets the depth of vibrato applied to the
reverb trail.
The Slötvå also features 3 different wave shapes accessible by holding down bypass while switching the algorithm toggle.
SINE – Smooth and even pitch up and down modulation.
WARP – Asymmetric pitch up modulation similar to a warped record.
SINK – Asymmetric pitch down modulation for sinking detune similar to a Bigsby.
MOMENTARY FUNCTIONS:
Bypass:
When the switch is in the off position, press and hold to temporarily
activate the effect to add a moment of reverb texture. Releasing the
switch turns the effect off, and fades it out.
Sustain:
When pressed, the decay switch ramps up the reverb trail to maximum
creating a long dreamy reverb trail, and then ramps back down to the
decay knob setting when released. In the “Dream” algorithm, the sustain
switch is latching. Press it once to capture and sustain the current
reverb decay for extremely long pad-like sounds. Press it again to let
the reverb trail taper off, based on the position of the decay knob.
TRAILS MODE:
The Slötvå
can run in trails or no trails mode. In trails mode, when you turn the
pedal off, the reverb decay dies off naturally. In no trails mode, the
decay is abruptly cut off when you turn the pedal off. To toggle between
either mode, hold down the bypass switch for 1 second while applying
power to the pedal. Unplug power and repeat to toggle to the other mode.
PRESET SPILLOVER
When scrolling through presets, there is only preset spillover if the
next preset is the same algorithm as the one preceding it. For example,
if your red and green presets are both in Dream mode, switching from
red to green will not cut your reverb trails.