www.MyGuitarSupply.com                                                                                                          
FREE Shipping on ALL orders to the United States!                                
Toll Free: 855-862-4441                               Email: myguitarsupply@gmail.com
 

Electro Harmonix Nano Bass Big Muff Distortion Sustainer with 9 volt Battery

Image 0 of Electro Harmonix Nano Bass Big Muff Distortion Sustainer with 9 volt Battery

Electro Harmonix Nano Bass Big Muff Distortion Sustainer with 9 volt Battery

$94.30

Electro Harmonix Nano Bass Big Muff Distortion Sustainer with 9 volt Battery Part Number: NBBMUFF

  27 available Add to Cart

The new Nano Bass Big Muff is the latest EHX bass guitar, effect pedal. It delivers that huge Bass Big Muff sound in a nano-sized package. With voicing inspired by the battle-tank green, Russian Big Muff and a classic Big Muff Pi layout of Sustain, Tone and Volume controls, it provides sounds ranging from a slight but satisfying grit to an over-the-top wall of bass fuzz.

Quick Specs

- Tailor your drive/distortion sound with Sustain, Tone and Volume knobs
- Features a Dry switch that mixes your dry bass, at unity level, with the Nano Bass Big Muff’s distortion
- True bypass for maximum signal path integrity
- Road worthy die-cast chassis
- 9Volt battery included

The Nano Bass Big Muff draws its roots from the legendary Sovtek battle-tank green Big Muff Pi manufactured in the ‘90s as well as from the original Electro-Harmonix Big Muff Pi from the early ‘70s. These Big Muffs are often employed by bass players to thicken up their sound or to give them over-the-top low end growl. The Nano Bass Big Muff takes the best characteristics from both of these classics and employs sonic elements that were specifically designed for your bass.

-OPERATING INSTRUCTIONS-

SUSTAIN Knob — adjusts the amount of sustain and distortion.

TONE Knob — provides a range of sounds from high treble to deep bass. As you turn the knob clockwise, treble increases and bass decreases.

VOL Knob — sets the output level of the distortion effect. When the toggle switch is set to DRY, the volume knob has no effect on the output level of the dry signal.

DRY Toggle Switch — when set to DRY mode, the original dry signal present at the input jack is mixed with the output of the distortion circuit. The level of the Dry signal is constant and will not change as you turn the Volume knob up or down allowing you to set the level of the distortion effect against your dry signal. Flip the DRY switch to the left, away from the DRY label, to mute the dry signal; now you will hear only Big Muff distortion.

Footswitch & Status LED — When the LED is lit, the Nano Bass Big Muff effect is active. When the LED is off, the Nano Bass Big Muff is in True Bypass mode. The Footswitch toggles between effect and bypass modes.

INPUT Jack – This ¼” jack is the audio input to the Nano Bass Big Muff. The input impedance presented at this jack is 110 k?.

AMP Jack – This ¼” jack is the audio output from the Nano Bass Big Muff.  When the Nano Bass Big Muff is in True Bypass mode, the AMP jack is connected directly to the INPUT jack.

9V Power Jack – The Nano Bass Big Muff Pi is powered from a 9V battery or you can use an optional 9VDC AC Adapter capable of delivering at least 25mA to the 9V power jack, such as the EHX9.6DC-200. The AC Adapter must have a center negative plug.  The battery may be left in or taken out when using an AC Adapter. The Nano Bass Big Muff has a current draw of approximately 4mA at 9VDC.