www.MyGuitarSupply.com                                                                                                          
FREE Shipping on ALL orders to the United States!                                
Toll Free: 855-862-4441                               Email: myguitarsupply@gmail.com
 

Electro Harmonix Hum Debugger Hum Eliminator Effect Pedal with Power Supply

Image 0 of Electro Harmonix Hum Debugger Hum Eliminator Effect Pedal with Power Supply

Electro Harmonix Hum Debugger Hum Eliminator Effect Pedal with Power Supply

$161.50

Electro Harmonix Hum Debugger Hum Eliminator Effect Pedal with Power Supply Part Number: HUMDEBUGGER

  27 available Add to Cart

Every musician battles hum in their signal chain. The Hum Debugger turns it into dead silence, courtesy of a little EHX magic. Not a noise gate, and not a noise suppressor -- but a real hum extractor. Silence is golden.

Quick Specs

- True bypass 
- Absolutely eliminates hum from any audio source 
- Tough and compact die-cast chassis 
- 7.5AC-400 power supply included 
- Dimensions in inches: 4.0 (w) x 4.75 (l) x 2.25 (h) 
- Dimensions in mm: 102 (w) x 121 (l) x 89 (h)

-CONTROLS and I/O Jacks-

NORMAL/STRONG TOGGLE SWITCH - Sets the amount of Hum Elimination. In NORMAL mode the Hum Debugger removes only the odd harmonics from the hum present in your signal. In STRONG mode the Hum Debugger removes both odd and even harmonics from your signal’s hum content.

STATUS LED - When the LED is lit the Hum Debugger is active. When the LED is off the Hum Debugger is in True Bypass mode.

FOOTSWITCH - Toggles the Hum Debugger between active and True Bypass modes.

CONNECTIONS - Connect your instrument to the INPUT Jack. Connect your amplifier or the rest of your effects chain to the AMP Jack.

POWER - Plug the barrel connector from the AC Adapter that came with your Hum Debugger into the power jack at the top of the Hum Debugger. Plug the AC Adapter into a solid wall outlet. You must use the AC Adapter that the Hum Debugger came with and the AC Adapter must have an output of 7.5VAC with the ability to supply at least 200mA of current. 

-Using the Hum Debugger-

There are no special tricks necessary when using the Electro-Harmonix Hum Debugger. You can use it like you would any other effects pedal. The only thing to remember is you must use the AC Adapter that the Hum Debugger comes supplied with.

When using the Hum Debugger first set the toggle switch to NORMAL mode. NORMAL mode should work well in most situations. If you find that the Hum Debugger is still letting some hum through then move the switch up to STRONG mode, this should remove the rest of the hum.

If you use more effects pedals than just the Hum Debugger we advise that the Hum Debugger be inserted at the beginning of the effects chain.