The new 44 Magnum guitar amp head provides 44 watts of clean and natural
power but can also deliver a true amplifier overdrive at the turn of a
knob. From your pocket to the stage, the 44 Magnum is the perfect
gigging and practice solution. Despite being described as a “guitar
head” the 44 has the character and control to work with any electric
instrument. Flip the brightness switch for a more defined top end. The
sweet tone of our legendary 22 Caliber but with an extra power edge that
can make a difference.
Quick Specs
44 watts of power into 8 or 16 ohms
Tone switch toggles between a neutral, flat setting and a Musical top end boost
Maximum headroom potential
Can be driven to a natural, true amplifier saturation
Fits in the palm of your hand
Comes with a 24DC-3000 power supply
Dimensions in inches: 2.75 (w) x 4.5 (l) x 2.1 (h)
Dimensions in inches: 2.75 (w) x 4.5 (l) x 2.1 (h)
-CONTROLS and JACKS-
VOLUME CONTROL — This knob controls the volume or loudness of the
amplifier. As you turn the VOLUME knob clockwise, the 44 MAGNUM’s output
gets louder. At a certain point in the VOLUME knob’s travel the output
will start to overdrive, at this point you are beginning to exceed 44
Watts on your loudest notes. Turning the VOLUME knob further clockwise
will produce a more overdriven sound which is the result of pure power
amp saturation.
BRIGHT/NORM CONTROL- When engaged, the BRIGHT switch adds a subtle
top boost or presence to your signal. When in the NORM position, the top
boost is defeated.
INPUT Jack- Plug the output of your guitar, effects pedals or any
other instrument into the INPUT jack using a standard ” instrument
cable. The input impedance presented at the INPUT jack is 2 Mohm.
8 — 16 ohm OUTPUT Jack — Connect the 44 MAGNUM’s OUTPUT jack directly to a speaker cabinet. 8 ohm - 16 ohm only.
WARNING: NEVER CONNECT THE OUTPUT OF THE 44 MAGNUM TO THE INPUT OF
ANOTHER AMPLIFIER, AN EFFECTS PEDAL, MIXER, COMPUTER, COMPUTER INTERFACE
OR OTHER SIMILAR DEVICE.
We recommend using a speaker cable between the 44 MAGNUM and speaker
cabinet as you would with any power amplifier, though you can get away
with using an instrument cable if absolutely necessary. The impedance of
the speaker cabinet must be rated between 8 ohm and 16 ohm. 8 ohm is
the ideal load for the 44 MAGNUM. Additionally the speaker cabinet must
have a power rating equal to or greater than the 44 MAGNUM’s output
power capability. We recommend a speaker cabinet with at least a 50W
peak rating (or 25W RMS).
WARNING: Make sure the 44 MAGNUM’s output is connected to a speaker cabinet before applying power.
24VDC/3A POWER Jack — Connect the output plug from the 44 MAGNUM’s
supplied power supply to the power jack at the top of the unit. Only use
the power supply that the 44 MAGNUM was supplied with. The 44 MAGNUM
requires a power supply capable of delivering at least 2A (more
available current is better) at exactly 24 VDC. DO NOT EXCEED 24 VDC ON
THE POWER JACK, doing so will damage the 44 MAGNUM. DO NOT CONNECT AN AC
POWER SUPPLY VOLTAGE TO THE 44 MAGNUM, USE DC POWER ONLY. The polarity
of the power jack is center positive.