- Dimensions in mm: 70 (w) x 115 (l) x 54 (h)
- USING THE BASS CLONE -
Use the footswitch to turn on the effect. The red status LED lights
to indicate that the effect is engaged. The sound you hear is a
combination of dry and modulated signal.
Adjust DEPTH to set the modulation amount and turn RATE to set the
modulation speed. Flip the X-OVER switch up to cut low end from the
modulated half of the signal; the effect will be more subtle on lower
notes. Engaging X-OVER helps you retain essential clarity and punch in
your low end while maintaining shimmering modulation in your high end.
BASS and TREBLE allow you to further shape the chorus tone by
boosting/cutting low end and high end respectively.
WARNING: Your Bass Clone can be used with an Electro-Harmonix
9.6DC-200BI power supply (same as used by Boss® & Ibanez®: 9.6 Volts
DC 200mA). The Bass Clone draws 15mA at 9VDC with a center negative
plug. Using the wrong adapter or a plug with the wrong polarity may
damage your Bass Clone and void the warranty.
- CONTROLS, I/O JACKS, POWER -
Footswitch & Status LED –The red LED illuminates when the effect
is engaged. The status LED glows brightly to signal that all operational
voltages are satisfactory. The LED will not light if the Bass Clone is
bypassed. Press the footswitch to toggle between effect on and true
DEPTH Knob – Controls the amount of modulation.
RATE Knob – Controls the speed of modulation.
BASS Knob – Boosts or cuts low end from the dry half of the effect signal. No boosting or cutting at 12 O’clock.
TREBLE Knob – Boosts or cuts high end from the mixed effect signal. No boosting or cutting at 12 O’clock.
X-OVER – Cuts low end from modulated half of the signal when switch is facing up.
INPUT Jack – Plug your instrument or the output of another effects
pedal into this ¼” jack. The input impedance is 2.2MOhm. The battery is
drained when a cable is plugged into this jack, regardless of bypass
AMP Jack – The AMP jack outputs the Bass Clone’s audio signal. The output impedance is 1KOhm.
9V Power Jack – The Bass Clone accepts 9V Batteries, and can also be
powered from an Electro-Harmonix 9.6DC-200 power supply. Plug the output
of the AC adapter into the 9V power jack located at the top of the Bass
Clone. The Bass Clone draws 15mA at 9VDC with a center negative plug.
The Bass Clone accepts Boss® and Ibanez® style AC Adapters capable of
delivering at least 50 mA.
- CHANGING THE BATTERY -
To change your 9V battery, remove the four screws on the bottom of
the Bass Clone. Take off the bottom plate and change the battery. Do not
touch the circuit board while the bottom plate is off or you risk
damaging a component